StarTechcom Computer Drive SATA35252X User Manual

SATA35252X

3.5” Bay to Dual 2.5” SATA HDD Adapter

Features

• Holds one or two 2.5” SATA hard drives

• Occupies a single 3.5” drive slot

• Includes 4-pin HDD to SATA power cable

Mounting

Brackets

(x6)

Board Indent

Stacking

Rails

Installation

WARNING! Computer equipment can be severely damaged by static electricity. Be sure that you are properly

grounded before opening your computer case or touching your hard drive. StarTech.com recommends that

you wear an anti-static strap when installing any computer component. If an anti-static strap is unavailable,

discharge yourself of any static electricity build-up by touching a large grounded metal surface (such as the

computer case) for several seconds. Be sure to handle your hard drive carefully and consult your hard drive

and laptop manufacturer for details on how to remove the drive.

Single Drive Installation

1. Place the 2.5” hard drive on a ﬂat, stable surface, label side down.

2. Place SATA35252X on top of the drive, such that the plastic fastening tabs are facing down, and the hard

drive mounting screw holes are aligned with the appropriate holes provided by SATA35252X.

Please note the drive outline that is printed on the board - by installing the drive within this spacing, the

drive interface is allowed to overhang the indent in the board, facilitating connectivity.

3. Fasten SATA35252X to the drive, using the screws provided. Once the drive has been secured to